1、功能说明
    此例程展示了代码下载到Flash，跳转到外部SDRAM内存中运行代码。

2、使用环境

    软件开发环境：KEIL MDK-ARM V5.34

    芯片支持：
		N32H785
		N32H785xxxxEC
		N32H787
		
	开发板支持：N32H787XIB7_HMI V1.0


3、使用说明

    系统配置
        1、时钟源：HSI+PLL
        2、系统时钟频率：
            M7 Core： 400MHz
        3、GPIO：
            PA4-D2
			
		4、LOG配置：
            TX  -->  PA9 
            波特率：115200
            数据位：8bit
            停止位：1bit
            无校验

    使用方法：
        1、编译后将程序下载到开发板并复位运行。
        2、可观察到D2间隔1s循环点亮。

4、注意事项
    无
    
1. Function description

    This example demonstrates that the code is downloaded to the Flash and then jumps to run in the external SDRAM memory.

2. Use environment

    Software development environment: KEIL MDK-ARM V5.34

    MCU support:
		N32H785
		N32H785xxxxEC
		N32H787
		
	Development board support:   N32H787XIB7_HMI V1.0
	

3. Instructions for use

    System Configuration:
        1. Clock source: HSI+PLL
        2. System Clock frequency: 
            M7 Core:     400MHz
        3.GPIO:
            PA4-D2
			
		4. LOG configuration:
             TX --> PA9 
             Baud rate: 115200
             Data bit: 8bit
             Stop bit: 1bit
             No verification

     Instructions:
        1. After compiling, download the program and reset, the program start running.
        2. D2 can be observed to light up cyclically at 1s intervals..

4. Attention
    None

